Drive Clutch Cleaning And Inspection - Pioneer 1200 Maintenance Service Manual

TORQUE CONVERTER
CAUTION
• Do not hit or tap the clutch with a hammer. Do not pry the clutch. These actions will damage
the clutch.

DRIVE CLUTCH CLEANING AND INSPECTION

1. Use a dry, lint-free cloth to clean clutch parts. See following CAUTION.
Use Club Car clutch holder
while tightening or loosening drive
clutch retaining bolt.
CLUTCH HOLDER
THREE BOSSES
IN GRAY
Figure 17-3 Loosen Retaining Bolt
CAUTION
• Do not lubricate the drive clutch. Lubricants attract dirt and dust, which interfere with proper
clutch operation.
• Use only a dry cloth to lightly wipe the shaft (7) of the fixed face assembly (Figure 17-7,
Page 17-8). Do not use a brush or steel wool. These will damage the surface of the shaft.
• Do not use solvents. Solvents will damage the lubricating characteristics of the bushings.
2. Inspect the belt contact surfaces of the clutch sheaves for wear. If any area of a sheave contact surface
has wear of 0.060-inch (1.52-mm) or more, the clutch should be replaced.
2003 Pioneer 1200/1200SE Gasoline Vehicle Maintenance and Service Manual
DRIVE CLUTCH
RETAINING BOLT
Hook clutch holder
on boss of pully
located behind drive
clutch...push down
on adjacent
boss with holder.
VEHICLE BODY
REMOVED FOR
CLARITY
DRIVEN
CLUTCH
DRIVE CLUTCH
Insert drive clutch
puller into drive
clutch, then tighten
puller to remove
hub.
DRIVE CLUTCH PULLER
(CCI P/N 1014496)
Figure 17-4 Drive Clutch Removal
17
Drive Clutch
Page 17-5