Zeiss Classic Diatal T Series Instructions For Use Manual page 18

Instructions for use
b) After shooting, pull out the knob (8 or 9) from the catch and set the zero
mark of the sub-ring (10) to the index point (11). Push knob (8 or 9)
down in the catch. The index is used to find the original location again for
later adjustments of the reticle (for other distances or other charges).
c) Do not forget: screw the cover (1) back on.
Note: On delivery of the Classic Series riflescope, the reticle is set at the
center of the adjustment range and the zero mark of the adjusting ring (10) is
set at the index mark (11). From this setting, adjustment upwards, downwards,
right and left is possible over half of the adjustment ranges given in the
following table.
The shot correction height for the riflescope with Bullet Drop Compensation
(BDC) is described in detail in the enclosed Bullet Drop Compensation user
instructions.
Classic Diatal/Diavari riflescopes are designed so that when activating the
reticle adjustment, a corresponding movement of the reticle itself to the cen-
ter of the image cannot be detected. The reticle always remains in the center
of the image for all adjustments!
16