Connections - Avidsen 112279 Manual

Additional 7" screen for the videophone, 2 wires for ylva 3, ylva 3+
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 21
MONITOR FOR COLOUR VIDEO INTERCOM

2 - CONNECTIONS

• Do not increase the number of insulating screw joints or connectors on the connecting wire between the
intercom panel and the monitor
• Keep the connecting wire between the intercom panel and the monitor more than 50 cm away from any
electromagnetic interference (230 V cable, WiFi device, microwave ovens, etc.)
• You can connect and use the electric strike plate (not provided) with your intercom panel, with or
without mechanical memory.
Between the monitor and the intercom panel (100m maximum)
To ensure good audio and video quality, it is advised to not use more than 100m of cable between the
intercom and the intercom panel. Connect the wires as follows (incorrect wiring can damage the intercom
panel).
The cable's length determines which cable section is to be used:
Cable length
0 to 50 m
50 m to 100 m
Between the intercom panel and an electric strike plate (not included)
Use a 12V/1.1A maximum electric latch with or without mechanical memory.
For the connection between the intercom panel and the door release, use a cable of this kind:
Cable length
0 to 50 m
Between the intercom panel and the automated gate (not included)
Section to use: Min. 0.75 mm2
Section to use
0.75 mm2
1.5 mm2
Section to use
0.75 mm2
C - INSTALLATION
9
EN

Advertisement

Table of Contents
loading

Table of Contents