Advertisement
SET WATER FLOW DURATION
Button
1.
− Switch the power to the controller off.
After 5 seconds switch the power on.
− Locate the light on the controller.
− Press the piezo button 4 times.
− The green light on the controller
should flash 5 times.
TROUBLESHOOTING
PROBLEM
Water is not flowing from
tap
Rate of flow inadequate
WARRANTY
The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty
Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied.
Galvin Engineering Pty. Ltd. hereby specifically disclaims all other warranties, express or implied, including but
not limited to the implied warranties of merchantability and fitness for a particular purpose.
Galvin Engineering Pty Ltd products are covered under our manufacturer's warranty available for download from
www.galvinengineering.com.au Galvin Engineering Pty Ltd expressly warrants that the product is free from
operational defects in workmanship and materials for the warranty period as shown on the schedule in the
manufacturer's warranty. During the warranty period, Galvin Engineering will replace or repair any defective
products manufactured by Galvin Engineering without charge, so long as the terms of the Manufacturer's
warranty are complied with.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for
breach of warranty, and Galvin Engineering Pty Ltd shall not be responsible for any incidental, special or
consequential damages, including without limitation, lost profits or the cost of repairing or replacing other
property which is damaged if this product does not work properly, other costs resulting from labour charges,
delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions,
chemical, electrical or any other circumstances over which Galvin Engineering has no control. This warranty
shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or
alteration of the product.
Controller
2.
− Once again, push the piezo button 5 times.
− The red light on the controller should now be lit.
− Leave the red light on for the desired flow
duration time.
− Press the button to finish setting the time.
CAUSE
Water is turned off
Blocked flow restrictor
The flow regulator screw may
not be adjusted correctly
th
Version 1, 16
June, Page 4 of 4
RECTIFICATION
Turn on water
Remove restrictor and clean
Remove blanking screw and adjust flow
regulating screw as described above
Advertisement
