Bachmann Williams O-27 ALCO DUMMY Instructions

Diesel locomotive

Download this manual

O-27 ALCO DUMMY DIESEL LOCOMOTIVE INSTRUCTIONS

Thank you for purchasing a Williams by Bachmann® locomotive. This locomotive has been manufactured to provide

years of use and enjoyment. Please follow the simple instructions below.

Before operating, please lightly lubricate the points shown in the diagram below. Do not over-lubricate and take extra care

to avoid getting lubricants on the wheel surfaces.

1. For the axles and coupler pivot points Marked A, we recommend that you lubricate with a small amount of light

oil such as Bachmann E-Z Lube® #99984 Light Gear Oil. Do not over-lubricate.

2. For areas that require electrical flow, such as roller pick-ups Marked B, please use Bachmann E-Z Lube®

#99981 Conductive Contact Lube. Never use any Teflon® based oil on these areas because this type oil has

insulating properties.

Bachmann Industries, Inc.

1400 East Erie Avenue, Philadelphia, PA 19124 USA

www.bachmanntrains.com

Customer Service Telephone 800-356-3910

– Page 1 of 2 –

Page 1 Bachmann E-Z Lube® #99984 Light Gear Oil. Do not over-lubricate. 2. For areas that require electrical flow, such as roller pick-ups Marked B, please use Bachmann E-Z Lube® #99981 Conductive Contact Lube. Never use any Teflon® based oil on these areas because this type oil has insulating properties.
Page 2 OPERATION After unpacking the locomotive, make sure that the uncoupling plunger is in the correct position with the pin inserted in the knuckle (see figure 1). Failure to do so will allow the uncoupling plunger to contact the center rail and a direct short will occur when power is applied to the track.
Page 3 Bachmann Industries, Inc. 1400 East Erie Ave, Philadelphia, PA 19124 USA www.bachmanntrains.com Customer Service Telephone 800-356-3910 Part Number Description Number Used O-27 ALCO BODY & BODY PARTS 2072-02-01 Die-Cast Chassis Complete 1-30180DPA 30 80 Body Mounting Screw(Front) ounting Sc ew( ont)