Advertisement
ADHESION TECHNIQUE
Preparation of adhesive surface
To increase the adhesive
force at profiles with the
surface: „black mat".
It is required to roughen
theadherend (surface)
with abrasive paper of
grain size 100.
1_ only surface: „black mat„
After placing the glass panel / handle or wooden panel
it should be careful pressed by using the pressure roller.
(ca 20 N / cm²).
5_ pressing the joining parts
Clean the adhesive surfaces
of the profiles and the back
of the glass with cleaner.
Use lint-free cloths:
The surface has to be free of
grease, oil or silicone films
as well as dirt particles.
Wait approx. five minutes
in order to give the sol-
vents time to evaporate.
2_ cleaner
Apply a thin layer of primer
/ promoter to the adhesive
surfaces.
Wait approx. five minutes
in order to give the sol-
vents time to evaporate.
3_ promoter / primer
pressure roller for double
sided tape
The processing
temperature should
not be below 20°c
pressure:
2
ca. 20 N / cm
4_ adhesive tape
pressure roller for glass
Applies to horizontal
positioning the glued
surfaces point upwards
adhesive force (50%)
at 20° C after 20 min
end adhesive force (100%)
at 20° C after 72 h
27
Advertisement
