Advertisement
ASSEMBLY INSTRUCTIONS
GLUING THE GLASS PANEL
Place the glass panel, insert profile for dividing rail, cover
for dividing rail and handle on the frame as a test and
if necessary align the frame again.
Information: Do not touch
the cleaned and primed surface!
7_ Preparation of gluing.
Please position the gluing device. Place the glass panel
on top and align it. Please make sure, that you
use glass suction cups to attach the glass panel.
Drive in the bolt of the gluing device and position
the panel exactly. Then push off the gluing
device from the bottom to the top.
bottom
9_ Perform this workstep by two persons / Precision work is very important!.
Clean and prime the adhesive surface, before gluing the glass
panel. Remove the protective film from the vertical profile,
horizontal bottom and top profile and the dividing rail.
Do not remove the protective film for dividing rail,
insert profile, cover and handle!
8_ Preparation of gluing.
top
align glass panel
13
Advertisement
