Advertisement
ADHESION TECHNIQUE
This instruction applies to the glass and aluminum gluing of the S 800 and
the wooden material, glass and aluminum gluing of the S 8000
General:
For safety reasons the back of the 4 mm glass panels must be covered with an adhesive safety backing (PE).
Please adhere to manufacturers' processing guidelines and safety regulations.
In order to ensure optimum adhesion you must adhere to the following steps!
The processing temperature must be above 20° C.
1_Clean the adhesive surfaces using 3 m surface cleaner VBH. Use a lint-free cloth for this purpose.
The surfaces must be free of grease, oil or silicon films and dirt.
2_Following this, wait approx. five minutes until all cleaner residues have evaporated.
3_Apply a thin film of primer to the adhesive surfaces (profiles and panels).
4_Following this, wait approx. five minutes until all primer residues have evaporated.
5_Apply the tape bubble-free adhesive tape to the profiles.
Following this use the pressure roller to roll it on firmly (approx. 20 N / cm²) and remove the protective film.
6_Apply to the glass panel and press on firmly.
Important: Do not touch surfaces which have been cleaned and primed.
The panels must be adjusted exactly before beginning the adhesion process.
The panel cannot be adjusted after adhesion!
end adhesive force (100%)
at 20° C after 72 h
7. After adhesion process and pressing of the components, it is advisable to store the element in a lying position
until the final adhesive force has been reached.
We reserve the right to make technical alterations. We recommend one attempt at fixing adhesive products.
26
adhesive force (50%)
at 20° C after 20 min
STANDARD
tesa
®
⇐
Cleaner : 3 M - Surface Cleaner VBH ( may be taken for all systems )
⇐
Promoter 60150
adhesive agent
plus
⇐
adhesive tape
ACX
7044
for S 8000 this
type of gluing is
essential!
GLUING:
OPTIONAL
⇒
System
⇒
Primer 94
⇒
4613F VHB
3 M
TM
TM
Advertisement
