Please check the completeness of the delivered parts and check carefully if any transport damages are visible. If any parts are damaged or lost, please immediately contact the responsible supplier. It is assumed that you have exactly identified all cutting dimensions according to the measurement instruction for raumplus products. SYMBOLS: Symbol Importance...
Page 4
PRODUCT INFORMATION GENERAL INFORMATION: Product safety The interior system Rima Fino complies with the prior of the art and the authorized safety rules at the time of delivery. Intended use USE: The prerequisite for the intended use of our products is the professional installation according to our installation instruction. Sufficient fittings must be available and...
Page 5
The shelves are guided on top and bottom track. Any other use that deviates from the specific proper use is not according to the raumplus regulations. Manual: Move the shelf slowly by hand. Guide the shelf slowly to the end position.
Page 7
ASSEMBLY INSTRUCTIONS PREPARATION OF THE PARTS Twister screw dowel DU 319 1_ Prepare sides 2_ Prepare top shelf with top fitting 3_ Prepare bottom shelf...
Page 8
ASSEMBLY INSTRUCTIONS ASSEMBLING THE SHELF 4_ Assemble construction shelf / sidewall and rear wall 5_ Mount second side and fix it with the fittings...
Page 9
ASSEMBLY INSTRUCTIONS ASSEMBLING THE SHELF Shelf support: screw Shelf support: side bracket Fix the screws tightly with 4 Nm! DIN 912 M5x25 Frame screw S26 4 mm 6_ Prepare for screwing the bottom rollers 7_ Fix the bottom roller After contact (tape with rear wall), position cannot be changed! The rear panel must be free of any dust...
10_ Push stopper into the bottom track before assembly 11_ Install moveable shelf with at least two persons To align the Rima Fino the bottom 4 mm rollers always need to be adjusted parallel 12_ Mount top fittings 13_ Finish Rima Fino with the shelves and damper...
Page 11
RIMA FINO DIMENSIONS The top rollers need Width: to lie approx: 15 mm min.: 600 mm deep inside the top track! max.: 800 mm Thickness of material: side panel / shelves: 12 mm rear wall: 10 mm Depth: glass / mirror: 4 mm min.: 180...
PLANNING EXTERNAL DIMENSIONS Width 71 mm (bottom track surface) 65 mm (bottom track insert)
Page 13
Planungshilfe PLANNING Rückwandposition POSITION OF THE REAR WALL Necessary requirements for stability: rear wall - a total of at least 2/3 of the cabinet height - rear wall at top edge and bottom edge - possible variants: Shelf width + 10 mm Top shelf Construction shelf Construction shelf...
Page 14
PLANNING DIVIDING WALL 190 mm Choice: 246 mm D e p t h o f t h e D e p t h d i v i d i n g w a l l o f t h e s h e l f w t h e w a l l i s m...
Page 15
PLANNING POSITION OF THE TRACKS · raumplus GmbH Dortmunder Straße 35 · 28199 Bremen · Germany · Tel: +49 (0) 421 / 579 50 0 · Fax: +49 (0) 421 / 579 50 11 · www.raumplus.com...