Page 2
Assembly Instructions 2/6 IMPORTANT * Do not tighten up all the screws until each part is properly assembled. * Use a soft cloth between these parts and the floor. STEP 1 Attach 2X Magnets to Top (A) by using Wood Screws (for Magnet) into the pre-drilled holes.
Page 3
Assembly Instructions 3/6 Figure 4 Figure 5 STEP 3 Attach Back Stretcher (G) to Side Panel (B), then filp the Locks. (See Figures 4 and 5) Attach Back Uprights (F) and slide Back Panels (E) into position. Attach Back Stretcher (H) and Side Panel (C) to unit, then filp the Locks. Figure 6 Non-Locking Caster Head Cap Bolt...
Page 4
Assembly Instructions Head Cap Bolt (long) STEP 5 Attach base unit to unit with Head Cap Bolts (long). Figure 7 Wood Screw (for Leaf Support) Wood Screw (short) STEP 6 Turn the unit to its’ upright position. Slide Towel Bar (L) into place.
Page 5
Assembly Instructions Adjustable Pin STEP 7 Insert Adjustable Pins into side panel and middle panel at the desired level. Place Shelves (S) into position. Attach Doors (Q) and (R) by sliding the door lift hinges into the side panels lift hinges. (See Figure ) 8 Figure 8 Assemble Pull Handles to Doors with Machine Screws.
Assembly Instructions 6/6 Drawer (T) STEP 1 Attach T1 to T3 and T4, using a Phillips screwdriver long wood screws (4X), tighten halfway. Attach T2 to T3 and T4 using long wood screws (4X), tighten halfway. (See Figure 1) MAKE SURE ROLLER IS ON THE BACK Figure 1 STEP 2...