■ABOUT THE BATTERY
1. Battery Life
When this timer is supplied with a new normal battery it will function for about three years.
This is based on a standard use pattern of five times (within 20 seconds, including also the
preliminary warning) of a two hour count every day with the TIME-UP MESSAGE set to VIBRATION.
When the timer is used more than this the battery may run out before the above time (3 years) is
reached.
You need to be particularly careful when you set the repeat number to a LARGE NUMBER OR
*
INFINITE and the select VIBRATION as the TIME-UP WARNING.
2. Initial battery (Normally included)
3. WATER RESISTANCE.
About Preliminary Warning that Battery is Running Out
When the
mark flashes, the battery is running out. Be sure to buy a new battery soon at the
*
store where you bought the timer.
When the
mark flashes the following functions cannot be used. Remember that this is not an
*
error.
• TIME-UP WARNING function: VIBRATION
When you have set the TIME-UP Warning function to VIBRATION and the battery runs out while the
*
timer is in use the BEEP SOUND lets you know that you cannot use the TIME-UP Warning Function
VIBRATION. You cancel (stop) the BEEP SOUND by pressing anyone of the buttons ¿,
once. The timer in use will then continue to count until the set time is over.
46
■PRODUCT SPECIFICATIONS
1. Liquid crystal oscillation frequency........32,768Hy (Hz = Number of oscillations per second)
2. Accuracy.................................Within ± 0.0012% at normal ambient temperature (5°C - 35°C)
(Converted to monthly error : Within ± 30 sec)
3. Operating temperature range.......................-5°C - +50°C. Display function: 0°C - +50°C)
4. Display............................................................FE (electric field effect) type nematic crystal
5. Battery............................................................Small lithium battery SB-T51 (CR2032 1 only)
6. Battery life......................................................Approx. 3 years
7. Electronic Circuit...........................................C-MOS-LSI (1 only)
As part of our policy of ongoing product improvement we reserve the right to change
*
these specifications without prior notice.
48
4. Battery Change
A For battery replacement, be sure to have the battery replaced with a new one at the retailer from whom the watch
was purchased, and specify a genuine battery. B If the old battery is left in the watch for a long time, a malfunction
may be caused due to battery leakage, etc. Have it replaced with a new one as soon as possible. C Battery
replacement is charged even if it runs down within the guaranteed period. D Once the case back is opened for battery
replacement or other purpose, the original water resistant quality designed for the watch may deteriorate when it is
closed. When you have the battery replaced with a new one, also request the water resistant test pertaining to the
water resistant quality of your watch. If your watch has 10-bar or higher water resistant quality, be sure to have such
test performed on the watch every time the battery is replaced. Please note that it takes several days to check the
water resistant quality of your watch. When requesting the checking, therefore, please check the period required for it.
When the battery is taken out of the timekeeper, keep it out of reach of children.
*
If children happen to swallow it, consult a doctor immediately.
WARNING
1. Do not remove the battery from the watch.
2. If it is necessary to take out the battery, keep it out
of the reach children.
3. If a child swallows it, consult a doctor immediately
as it will adversely affect the health of the child.
4. Never short-circuit, tamper with or heat the bat-
tery, or never expose it to fire as it may explode,
¡
¬
or
generate an intense heat or catch fire.
CAUTION
・The battery is not rechargeable. Never
attempt to recharge it, as this may cause
battery leakage or damage to the battery.
・If the watch is left in a temperature below
-10°C or above +60°C for a long time, bat-
tery leakage may result to shorten the
battery life.
47