Setting The Delay Using Gpib (Ieee488.2) Commands; Using National Instruments Measurement And Automation Explorer - Colby Instruments PDL-100A Operating And Programming Manual

Chapter 4

4.5.3 Setting the delay using GPIB (IEEE488.2) Commands

GPIB commands can be sent to the PDL-100A by using one of many GPIB
command Send and Receive programs available on the PC. This program should
be included with the GPIB PC board.
4.5.4 Using National Instruments Measurement and Automation
Explorer
1. From Windows Desktop, double-click on the Measurement & Automation
Explorer Icon.
2. In the Configuration Panel, click on Device and Interfaces under Devices
3. Click on your installed GPIB board e.g. GPIB0 (PCI-GPIB+) Folder
4. Click Scan For Instruments button
5. Double-click on Instrument0 (or corresponding instrument attached)
© 2010 Colby Instruments. PDL-100A Operating and Programming Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Setting Delay Values
Page 23