For your convenience, record the model number and serial number (you will find them on the bottom side of your set) in the space provided below. Please refer to them when you contact your AIWA dealer in case of difficulty. Model No. CDC-X917M Serial No.
PRECAUTIONS • Use only in a 12-volt DC negative-ground electrical system. • Disconnect the vehicle’s negative battery terminal while mounting and connecting the unit. • When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage rating may cause serious damage to the unit.
THEFT PROTECTION (Retractable Front Panel) When your car’s ignition switch is turned off, the front panel will be retracted automatically as if there were no car audio in the console. When the ignition switch is set to ACC or ON position, the front panel will appear automatically.
Muting button beep sounds Turn off the unit. Press and hold SEL until “BEEP” appears in the display. Press + or – to select “ON” or “OFF”. Press SEL. The unit turns off. Setting the clock Press and hold SEL until the clock indicator flashes in the display.
Presetting stations manually (Manual Memory) Press FUNCTION repeatedly to select the desired band (F1, F2, F3, A1 or A2). Press TUNEi or TUNEk to tune in to a desired station (see “Tuning in to a station,” page 3). Press and hold the desired preset station button until the unit beeps.
Labeled-side up CD indicator Elapsed playing time Track number Press Eject a CD Skip to the next track Go back to the beginning of the current track Each extra press skips backward one extra track Locate a specific point in Press and hold r or a track t until you find the...
Press and hold to switch to the next CD. CD CHANGER OPERATION Playing a CD You can play CDs from a connected AIWA CD Changer. For detailed information on installing a CD Changer, refer to the Installation and Connection manual supplied with the CD Changer.
Random Play. CD text information (Disc and Track title) CD text information is available only if the optional AIWA CD changer (ADC-EX108, etc.) which supports CD text, is connected to this unit and a CD with CD text is played on it.
Page 10
PRECAUCIONES • Utilice el aparato solamente en un sistema eléctrico de tierra negativa de 12 volt CC. • Desconecte el terminal negativo de la batería del vehículo antes de montar y conectar el aparato. • Al cambiar el fusible, ponga uno de amperaje idéntico. Si se utiliza un fusible de mayor amperaje, se pueden producir serios daños en el aparato.
PROTECCIÓN ANTIRROBO (Panel Frontal Retractable) Cuando el contacto del coche es apagado, el panel frontal será retractado automáticamente como si no hubiera ninguna radio en el coche. Cuando el contacto del coche es ajustado a la posición ACC o ON, el panel frontal aparecerá automáticamente. OPERACIÓN BÁSICA, AJUSTE DEL SISTEMA AUDIO Y DEL RELOJ...
Para silenciar los pitidos de los botones Apague el aparato. Pulse y mantenga apretado SEL hasta que la expressión “BEEP” aparece en la pantalla indicadora. Pulse + o – para seleccionar “ON” (encendido) o “OFF” (apagado). Pulse SEL. La unidad se apagará. Ajuste del reloj Pulse y mantenga apretado SEL hasta que el indicador del reloj se haga intermitente en la pantalla.
Preconfiguración manual de estaciones (Memoria Manual) Pulse FUNCTION varias veces para seleccionar la banda deseada (F1, F2, F3, A1, ó A2). Pulse TUNEi o TUNEk para sintonizar la estación deseada (ver “Sintonización de estaciones”, página 3). Pulse y mantenga apretado el botón de la estación preconfigurada que se desea, hasta que el aparato emita un pitido.
La etiqueta hacia arriba Tiempo de reproducción Indicador de CD transcurrido Número de sección Para Pulsar Expulsar un CD Saltar a la sección siguiente t Volver al principio de la sección en curso Cada pulsación añadida salta hacia atrás una sección Localizar un punto Pulsar y mantener específico dentro de...
CAMBIADOR DE CD Reproducción de CD Se pueden reproducir CDs a partir de un cambiador de CD AIWA conectado al aparato. Para información más detallada sobre la instalación de un cambiador de CD, consulte el manual de instalación y conexión que viene con el mismo.
Si la indicación del código de error no desaparece, consulte en un centro de servicios de AIWA. ERROR01 La bandeja de discos no está bien metida en el cambiador de CDs. Vuelva a meter la bandeja.
Page 17
GENERAL Voltaje del suministro eléctrico: 14,4 V (11 a 16 V permisibles), CC, tierra negativa Impedancia de carga: 4 Ω Control de tono: Graves ± 10 dB a 100 Hz, Agudos ± 10 dB a 10 kHz Voltaje de la salida de la preamplificación (impedancia de carga): 4 V (10 kΩ) Tamaño instalado: 182 (An) x 53 (Al) x 155 (Pf) mm VOLANTE DE CONTROL REMOTO...
Page 18
PRÉCAUTIONS • Utilisez uniquement un circuit électrique 12 V CC avec négatif à la masse. • Débranchez la borne négative de la batterie avant de monter et de raccorder l’appareil. • Lorsque le fusible doit être remplacé, veillez à utiliser un fusible de remplacement de même calibre.
PROTECTION ANTIVOL (Panneau Frontal Escamotable) Quand l’allumage de votre voiture se met en arrêt, le panneau frontal sera escamoté automatiquement comme s’il n’ y avait pas de radio d’automobile sur la console. Quand l’allumage est calé sur les positions ACC ou ON, le panneau frontal apparaîtra automatiquement.
Mise en sourdine du son émis par les touches Mettez l’appareil hors tension. Maintenez l’appui sur SEL jusqu’à ce que l’indication “BEEP” apparaisse sur l’afficheur. Appuyez sur + ou – pour sélectionner “ON” ou “OFF”. Apuyez sur SEL. L’unité est hors tension (off). Réglage de l’horloge Maintenez l’appui sur SEL jusqu’à...
Préréglage manuel des stations (Mémorisation Manuelle) Appuyez plusieurs fois sur FUNCTION sélectionner la bande désirée (F1, F2, F3, A1 ou A2). Appuyez sur TUNEi ou sur TUNEk pour vous caler sur la station de votre choix (voir “Accord sur une station”, page 3). Maintenez l’appui sur la touche de la station préréglée souhaitée jusqu’à...
Côté portant l’étiquette dessus Témoin CD Temps de lecture écoulé Numéro de titre Pour Appuyez sur Éjecter un CD Passer au titre suivant Revenir au début du titre courant Chaque appui supplémentaire fait passer au titre qui précède Situer un point Maintenez l’appui sur r particulier dans le titre ou sur t jusqu’à...
Maintenez l’appui pour sélectionner le CD suivant. CHANGEUR DE CD Lecture d’un CD Vous pouvez lire des CD sur un changeur de CD AIWA connecté. Pour avoir des informations détaillées sur l’installation d’un changeur de CD, reportez-vous au manuel d’installation et de connexion fourni avec le changeur de CD.
L’information CD texte (Nom du disque et du Titre) L’information CD texte est disponible uniquement si le changeur de CD AIWA optionel (ADC-EX108, etc.) qui supporte le CD texte, est connecté à cette unité et le CD avec CD texte est lu.
Page 25
COMMANDE À DISTANCE AU VOLANT Dimensions : environ 67 (L) x 26 (H) x 27 (P) mm (sans le support) Poids : environ 38 g (y compris le support et la pile) Accessoire fourni : Nécessaire de montage (1 jeu), pile au lithium (1) •...