Activating The Training Safety Shutdown - Segway i2 SE Manual

Segway PT Product Orientation
You have approximately 10 seconds from the start of
a Safety Shutdown to come to a controlled stop and
step off. After 10 seconds, the Segway PT will
immediately shut down when the Wheels reach zero
speed. If a Safety Shutdown occurs, immediately
come to a controlled stop and carefully step off one
foot at a time.

Activating the Training Safety Shutdown

The purpose of demonstrating Safety Shutdown for
training purposes is to introduce the rider to the
experience while in a predictable, controlled
environment with a spotter.
First, the Coach should demonstrate the Training
Safety Shutdown, then the Coach should spot the
Rider as the Rider experiences the Training Safety
Shutdown. Read all the following steps prior to
activating the Training Safety Shutdown
For the Coach:
Explain that you are inducing a Safety Shutdown for
training purposes, to simulate the alert the rider would
get if a critical component failed, or if the batteries are
run too low.
1. Make sure the Segway PT is in Balance Mode.
2. Stand on the Mats with the Segway PT
remaining stationary.
3. Press and hold both the Information Display
button and the Power/Standby button
simultaneously until the Safety Shutdown
initiates.
4. Step off the Segway PT before 10 seconds
elapses. After 10 seconds, the Segway PT will
immediately shut down when the Wheels
reach zero speed.
Page 10 of 29
Coach's Manual
<<respond>>
You MUST step off within 10
seconds.
The Coach demonstrates the
Safety Shutdown
p/n __________________
© Segway Inc. 2015 All rights reserved
> i2 > x2