Sound Adjustments - Aiwa CT-X429 Operating Instructions Manual

TAPEPLAYBACK
SOUND ADJUSTMENTS
Tape transport display
When you stari tape playback, the transport
display indicates the tape movement.
Upper side: During playback
C( _&t
..+
Lower side: During playback
I ii+_)2
..+
During fast-forwarding or rewinding, "TAPE
indication flashes.
Before turning the ignition off
Be sure to eject any cassette from the unit before
turning the ignition off. Otherwise, the unit may
be damaged when you detach the front panel.
Switching modes
When the unit is in Radio or CD Changer Play
mode, inserting a cassette switches the unit to
Tape Play mode automatically.
To prevent tape problems
Before inserting a cassette into the unit, make
sure that there is no slack inthetape. If necessary,
take up the slack by inserting a pencil into the
spindle hole and winding.
90-minute or longer tapes are extremely thin and
easily deformed or damaged. They are not
recommended.
21
1
2
MUTE
Press SEL to select the mode that you
wish to adjust from: VOL
(volume),
BASS (bass), TRE (treble), BAL
(balance) and FAD (fader).
The following indications are displayed in
cyclic order.
1 I
If you do not proceed with step 2 within 5
seconds, the selected mode is canceled, and
the indication returns to the current source
mode.
Press +/- to adjust the level.
Press and hold either button to change the
level rapidly.
+
Decreases the Increases the
i'9Lvolume level
volume level
Decreases the
1!4s5bass level
Increases the
bass level
TI?E
Decreases the Increases the
treble level treble level
Decreases the Decreases the
y~~
level of the right
level of the left
speaker(s) speaker(s)
Decreases the
Decreases the
FH]
level of the front level of the rear
speakers speakers
Without selecting any mode with SEL, only
the volume level can be adjusted by pressing
+/–.
MUTE button
Press this button to temporarily lower the volume.
Press it again to restore the previous volume.
1 I ENGLISH