Troubleshooting; Maintenance - Aiwa CT-X429 Operating Instructions Manual

TROUBLESHOOTING MAINTENANCE
Error codes
In the following cases the corresponding error
code indication appears. Foilowthe suggestions
below to solve the problem. If the error code
indication does not disappear, consult an AIWA
service center.
ERROROI
ERROR02
ERROR03
ERROR04
ERROR05
The disc magazine is not properly
inserted in the CD changer.
Reinsert the magazine. Refer to
the instruction manual for the CD
changer.
No discs are loaded in the disc
magazine. Insert discs properly.
Refer to the instruction manual for
the CD changer.
Focus error. Check thatthe discs
are loaded properly in the disc
magazine (right side up, etc.).
Problem with the CD changer.
Reset the unit by pressing the reset
button. If this does not solve the
problem, consult an AIWA service
center.
The CD changer is overheated.
Allow the changer to cool off by
moving the vehicle out of direct
sunlight.
Reset button
The Reset button
is visible when you detach the
front panel. Trypressingthis button if a connected
CD changer does not operate properly. To press
this button, use the tip of a pointed object such as
a pencil or toothpick.
Note that all your setting stored in memory,
however, will be erased by pressing this button.
Cleaning the front panel
When the front panel is
soiled, wipe the surface
c~fthe panel with a dry and soft cloth.
Cleaning the tape head
lJse a cleaning cassette to clean the playback
head and capstans approximately once a month.
Illthe playback head
is dirty, the high tones may
riot be reproduced properly.
Cleaning the connector
The connector on the reverse side of the front
Panel needs to be cleaned occasionally. Wipe
the surface of the connector with a cotton swab
slightly moistened with alcohol.
.
r
0
2
Reset
button
ENGLISH 16