Setting Up A Custom Controller Pc - Agilent Technologies 81250 ParBERT Installation Manual

Setting Up a Custom Controller PC

Agilent 81250 ParBERT Installation Guide, May 2004
• The name of the system administrator is Administrator (not case
sensitive). His password is DVTADM (in capitals).
An administrator has universal access rights. For example, you must
log on as administrator if you wish to add users, change user
permisssions, or update the ParBERT software.
• There is one user installed. His name is dvt (not case sensitive), and
his password is DVT (in capitals).
The user dvt is defined as a "Power User".
• The administrator and user passwords are set to "never expire". For
security reasons, it is recommended to change these passwords
occasionally.
• The Windows automatic log-on script is enabled. After power on, you
are automatically registered as the user dvt.
The auto log-on feature makes it possible to start the computer without
manual intervention.
• The GPIB interface is set to address 11 and configured as a listener.
Setting Up a Custom Controller PC
The recommended operating system is Microsoft Windows 2000 or
Windows XP with updated service packs installed.
TI P
If you wish to start ParBERT automatically after power-on, consider
setting up a ParBERT user and enabling the auto log-on feature for this
user.
NOTE
If you are using Windows NT (service pack 6 is required), a TCP/IP
network must be set up, even if the controller is not connected to the
LAN. TCP/IP support is required by the Agilent 81250 firmware server.
3 Setting Up the ParBERT Controller PC
3-3