Agilent Technologies 81250 ParBERT Installation Manual page 55

How to Configure the IEEE 1394 and GPIB Interfaces
Agilent 81250 ParBERT Installation Guide, May 2004
Note that the default VISA name for the first PC-to-VXI interface is
VXI0.
5 If you have installed the 82350 PCI GPIB card, configure this as well.
Figure 24 GPIB Interface Configuration Options
You can use ParBERT as a GPIB controller. If you wish to connect
ParBERT as a listener to the GPIB, disable the System Controller
checkbox.
When you terminate IO Config, the software will update the firmware of
the E8491 PC-to-VXI interface modules installed in the VXI mainframes.
Please wait until the update process has finished.
After that, you are ready to install the ParBERT user software.
5 Putting ParBERT into Operation
5-5