Getting Started; Section 2 Getting Started - AIPTEK AHD-H23 User Manual

Loading the Battery
Before using the camcorder, you must load the Lithium-ion
rechargeable battery come within the package.
1. Insert the battery according to the correct polarity marks ( + or
-).
2. Close the battery cover firmly.
Charging the Battery
Please charge the battery for at least 8 hours prior to its first use. Afterwards,
it will take approximately 4 or 5 hours to fully charge the battery by AC
adapter. The camcorder must be turned OFF. The blinking light confirms
the camcorder is currently charging, and the light becomes constant after
the charging is completed. In AC charging Mode, the light will turn itself
off automatically after 3~5 minutes. (Actual charging time may vary. It
depends on the battery conditions.)
Inserting and Removing an SD Card (Optional)
The camcorder comes with an internal memory that allows you to store
photos and videos. You can expand the memory capacity by using an
optional SD memory card.
1. To inset a memory card, please refer to the figure on the right side.
2. To remove the memory card, please press the card and it will pop
up. Then pull the card out of the slot.
Note
• When a memory card is fitted, videos/photos are saved
to the card rather than the built-in memory.
• Protecting Data on an SD Card: SD Card is read-only
when it is locked. No photos or videos can be recorded
when the SD card is locked. Make sure the lock is on
the writeable position before recording any media.

Getting Started

Writeable
7
Section 2
Write-Protected
position Position
EN