HP ENVY x360 15m Maintenance And Service Manual page 51

10. Release the ZIF connector (10) to which the fingerprint reader board cable is connected, and then
disconnect the fingerprint reader board cable from the system board.
11. Remove the seven Phillips M2.0 × 3.2 screws (1) that secure the system board to the computer.
12. Lift the left side of the system board (2) as far as the power connector cable allows.
13. Disconnect the power connector cable (3) from the system board.
14. Remove the system board (4) by sliding it up and to the left at an angle.
NOTE: When removing the system board, make note of the location of the I/O bracket (5). The I/O bracket
is not available as a spare part component.
Reverse this procedure to install the system board.
System board 45