E-matic PMWSM Instructions

PMWSM
Instructions
The use of occupancy detectors can significantly reduce energy usage lessening both energy
costs and helping the environment.
DETECTOR uses microwave (5.8GHz) by the slight motion of persons or objects passing
through its detection area. Heat does not affect the sensitivity but detection is possible through
doors, panes of glass or thin walls.
automatically operates the connected load when an area is occupied.
After a preset time on non-activation (when an area is vacated) the
load will be switched off. In addition the built in photocell takes natural
light (daylight) into account when determining its activation.
SPECIFICATION:
Power Sourcing: 230v /AC
Power Frequency: 50/60Hz
Ambient Light: <3-2000LUX (adjustable) HF System: 5.8GHz CW radar, ISM band
Time Delay: Min.10sec±3sec
Max. 12min±1min
Rated Load: 1200W
300W
LED Load: 150W
FUNCTION:
The "LUX" adjuster adjusts the operation of the PIR in different ambient light. If adjusted to
the "sun" position (max) then the sensor will operate in daytime and at night. If adjusted to
the "3" position (min) then the sensor will only work when the ambient light is less than
3LUX. The "TIME" adjustment will determine the duration of the lights stays on for.
If the sensor has been activated then the timer is reset every time the PIR is still being
activated with the lights on.
SENS adjustable: It can be adjusted according to the location of the sensor. The detection
distance of low sensitivity could be only 5m and high
sensitivity could be 15m which fits for large room.
The PMWSM is a semi-flush mount OCCUPANCY
The microwave sensor
Detection Range: 180°
Detection Distance: 5-15m (adjustable)
Transmission Power: <0.2mW
Installing Height: 1-1.8m
Power Consumption: approx 0.9W
Detection Motion Speed: 0.6-1.5m/s
IP Rating: IP20
Ematic_PMWSM_Instructions_Rev01