E-matic PMWS Manual

PMWS
WALL SENSOR
Main Body
Lens
Slide Switch
INTRODUCTION
The PMWS 110 degrees Surface Mount PIR Wall
Switch is a fully automatic indoor controller capable of
controlling up to 2000W incandescent or 600W
fluorescent lighting. It uses a passive infrared sensor
which reacts to changes in temperature emitted by the
motion of persons or objects passing through its
detecting area. When you enter the room, it turns
on automatically the light to which it is connected and
the light remains lit as long as the wall switch senses
any activity in the detection area.
automatically turn off the light after the preset turn-off
time has expired. During the day, the built-in
photocell sensor saves electricity by deactivating the
light.
The PMWS is a very handy device, which offers you
safety, security, convenience and energy saving. It
is also easy to install and is suitable for the following
places:
living room, family room, stairways, entrance hall etc.
With this wall switch installed, you remove the
problem of searching in a dark hallway or staircase for
a light switch, thus avoiding danger for the elderly,
infirm and children at night or in dark areas.
Note : Read this entire manual before you start to
install the system.
SAFETY PRECAUTIONS
Be sure to switch off power source before
installing.
Make sure that the power wiring comes from
circuit with an external miniature circuit breaker
not higher than 16A for the short circuit protection
or a suitable fuse.
ES205
It however will
This unit cannot be installed on the ceiling.
(FIGURE 1)
FIGURE 1
IMPORTANT
Some local building codes may require installation
of this product by a qualified electrician.
Check your local codes as they apply to your
situation. If the house wiring is of aluminum,
consult with an electrician about proper wiring
methods.
Before proceeding with the installation, TURN OFF
THE POWER TO THE LIGHTING CIRCUIT AT
THE CIRCUIT BREAKER OR FUSE BOX TO
AVOID ELECTRICAL SHOCK.
CHOOSING A MOUNTING LOCATION
For the best results, fix your sensor on a solid
surface, 1.2~1.5m above the ground.
Avoid aiming the motion sensor at pools, heating
vents, air conditioners or objects which may
change temperature rapidly.
Do not allow sunlight to fall directly on the front of
unit.
Try to avoid pointing the unit where the motion of
pets may be detected.
Prior to mounting, remember to position the
motion sensor so that a moving object cuts
across its beams, not directly towards them.
(FIGURE 2)
FIGURE 2