Advertisement
16. Filling the Water Tank
Fill fresh water (without additives) into the tank up to the mark-
ing.
17. Speed Regulation
The suction power can be adjusted via the speed regulation.
Turn the controller clockwise to increase the suction power and
counter-clockwise to decrease the suction power.
18. Automatic Dust Suction
Connect the electric device with the suction hose and the
mains plug of the multi-functional cleaner.
Please check when using this vacuum cleaner to remove sanding dusts, that the type of dust is suita-
ble for the vacuum cleaner.
Switch the on/ off switch to the = position, after installing the connections. When turning the connected
electric device on, the vacuum cleaner will turn on with a short delay of approximately one second.
After using the electric device and switching it off, the vacuum cleaner will switch of after c. 10 sec-
onds.
Equipment
Floor nozzle – to clean carpets (dry cleaning) and hard surfaces (wet cleaning).
Crevice nozzle – for hard to reach areas e. g. corners, radiators.
Floor brush – to dust off highly sensitive furniture or scratch sensitive objects.
Wet/ dry nozzle – to vacuum moisture. Can also be used as a floor nozzle.
22. Emptying the Filter Bag
Open the clear cover on the top of the cleaner.
23. Emptying the Filter Bag
Open the filter bag on the bottom by removing the cover and
empty out the bag. Close it and place it back again.
24. Emptying the Water Container
Remove the upper part of the cleaner and remove the dirty
water. Clean the water container with clean water.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Artikel 00000
Seite 8
11
2020-1
Advertisement
