Seat Final Assembly; Operation Of Sliding Seat - Rans S-21 OUTBOUND Text Manual

RANS S-21 OUTBOUND
8. Bolt the Headrest Frame to the Seat Back Frame. Cut the Headrest Internal Tube
to length from Raw Stock. File the ends of the tube to match the angle of the
Headrest Frame for best fit.
HINT: Cut the Internal Tube long, file to length, and chamfer the ends of
the Internal Tube to fit over the washers (buttons).
9. Loosen the Headrest Frame from the Seat Back and snap the tube onto the
buttons. Check for a tight fit of the Internal Tube.
1. Pull Seat Back Cushion over Seat Back Frame. Flap of Seat Cushion will wrap
around bottom of Lower Seat Back Plate.
2. Pull Seat Bottom Cushion over Seat Bottom Frame. The large lower pocket will
slide over the Seat Bottom Frame. Wrap Aft Flap around Seat Internal Tube.
3. Velcro the flap of the Bottom Cushion to the Back Cushion.
4. Locate the #11 holes drilled through the lower side of the Seat Bottom Frames
(approx 8 1/4" from the aft end of the frame), and burn through the fabric on each
frame.
5. Press Slider Block onto covered Seat Bottom Frame with hole aligned with
burned hole.
NOTE: The long leg of Slider block should be to inside of Seat Bottom
Frame. Rivet in place.
6. If Head Rest is installed. Find the locations of the 4 Rivet Nuts for the headrest
and melt through with the tip of a soldering iron or hot knife. Bolt on the Headrest
Frame with the Internal Brace Tube in place. Slip the Headrest Cover over the
frame and close the Velcro flap around the tube.
7. Re-install seats during final assembly.
1. The sliding feature of the seat allows quick adjustment of the seat position while
sitting in the seat. To change seat position grasp the Seat Back and lean forward,
pulling the Seat Back forward with you.
NOTE: Lean forward far enough to allow the 1/4" Quick Pins to disengage
from the notches in the Sliding Seat Position Rail bolted under the square
fuselage seat rail.
2. Grasp the Main Spar Carry-thru Tube as a handhold and use it to pull or push
yourself and seat to desired position. Lean back allowing the 1/4" Quick Pins to
lock into position between the notches under the square seat rail. Check to be
sure seat has locked in position.
TEXT MANUAL

SEAT FINAL ASSEMBLY

OPERATION OF SLIDING SEAT

104
09/11/2018