Table of Contents
Advertisement
TROUBLESHOOTING
PROBLEM
Shear Fails to
Cut Through
Metal Fully
Air Flows
Through Shear
But Cutting
Blade Does
Not Move
ADDITIONAL ITEMS
#13474
Eastwood Pneumatic Metal Shear Replacement Blade Set
#28038
Eastwood Sheet Metal Thickness Gauge
#21299
Tilman Cut Resistant Gloves
#21297
Tilman True fit Work Gloves
#20257
Eastwood Sheet Metal Layout Kit
#14752Z
CRC Blue Layout Fluid
The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: tech@eastwood.com
© Copyright 2020 Eastwood Automotive Group LLC
CAUSE
Metal too thick.
Cutting Blades
worn
A metal chip
likely has
become
lodged in the
Cutting Blade
Assembly
If you have any questions about the use of this product, please contact
PDF version of this manual is available at eastwood.com
The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA
800.343.9353 eastwood.com
CORRECTION
DO NOT attempt to exceed 18 gauge (0.050")
[1.2mm] mild steel, aluminum and copper or
20 gauge maximum (0.036") [0.91mm] for
stainless steel.
Replace Cutting Blade set with Eastwood #13474.
Disconnect Shear from air supply and use a small
screwdriver or punch to move the Cutting Blade.
After moving the Blade, reconnect to air sup-
ply and depress paddle. Shear should function
normally.
If moving the Blade does not clear the chip, follow
Blade Removal only to Step 3 then reassemble.
5/20
Instruction item #13743Q
Rev 1
Advertisement
Table of Contents
