IBM 5710 Installation And Using Manual page 50

Signal Name
Ground
Ground
Ground
Ground
Ground
Ground
Ground
Note:
v 8-bit SE devices that connect to the P-cable should tie the following signals inactive high: –DB(8), –DB(9),
–DB(10), –DB(11), –DB(12), –DB(13), –DB(14), –DB(15), –DB(P1), and float the same signal lines.
v 8-bit LVD devices or SE mode, the following signals must be tied inactive (+ = inactive low, – = inactive high):
+/–DB(8), +/–DB(9), +/–DB(10), +/–DB(11), +/–DB(12), +/–DB(13), +/–DB(14), +/–DB(15), +/–DB(P1). Floating
these signals is not sufficient.
v All other signals shall be connected as defined.
38
PCI-X Dual Channel Ultra320 SCSI Adapter Installation and Using Guide
+C/D
+REQ
+I/O
+DB(8)
+DB(9)
+DB(10)
+DB(11)
Connector
28 62
29 63
30 64
31 65
32 66
33 67
34 68
Signal Name
-C/D
-REQ
-I/O
-DB(8)
-DB(9)
-DB(10)
-DB(11)