Installation; Integrating Devices Into The Hama Smart Solution App - Hama 176547 Operating Instruction

4.6.2 Installation

• You can attach the camera using adhesive pads.
• Power can be supplied to the camera only via USB.
• For USB operation, connect a Micro-USB cable (included
in delivery) to the Micro-USB port and to a suitable USB
power supply (included in delivery). Plug the power
supply unit into a socket. Connect the product only to a
socket that is approved for the device. The socket must
be installed close to the product and must be easily
accessible. When powering the device using a USB
power supply, make sure there are no batteries inside
the device.
Warning - Installation with adhesive pad
• All parts are intended for indoor use only. Do not
install them outdoors.
• Please note that the installation surface you choose
should be free of dust and grease. Use a suitable clean-
ing agent from a specialised dealer to clean the surface.
• Note that the adhesive pad attachment is permanent.
To remove the adhesive pad, carefully pull it off the
installation surface.
• Various environmental factors such as ambient
humidity, sunlight or cold can impair the durability of
the adhesive pad.
• We cannot guarantee that residue will not be left on the
mounting surface after the adhesive pad is removed.
4.6.3 Integrating devices into the Hama Smart
Solution app
• Connect the WiFi camera to the USB cable supplied and
the power supply unit. Plug the power supply unit into
a socket.
• Wait a moment until the camera emits a signal tone and
the LED begins to flash red.
• Open the app and tap 'My home' at the lower-left edge
of the screen.
• Then tap '+' at the upper-right edge of the screen,
select the 'Cameras' category followed by item number
'00176566'.
• Tap 'OK' to confirm that the camera is flashing.
14
• Then enter the name of your WiFi network and the
password. Tap 'OK' to confirm your entries.
• Now scan the QR code with the camera. Tap 'I heard
the beep' to confirm that you heard a signal tone. The
camera will now be connected.
• Once the connection has been established, the LED stops
flashing quickly and emits a constant blue light; the app
confirms that your camera was connected. You can now
give the camera a name.
• Click 'Finish' to complete the process.
• Now you can attach the camera and set up, control and
configure it using the app.