Table of Contents
Advertisement
1.
Understand that your safety and the safety of other persons are measured by how you service and operate this machine. Know the
positions and functions of all controls before you try to operate them. Check all controls in a safe area before starting your work.
2.
The safety information given in this manual does not replace safety codes, federal, state, or local laws. Ensure your machine has the
proper equipment as designated by local laws and regulations.
3.
A frequent cause of personal injury or death is from persons falling off equipment and being run over. Do not permit persons to ride
on this machine.
4.
Secure safety chain to towing vehicle before transporting. Do not transport without safety chains being attached to tow vehicle.
IMPORTANT: USE ONLY 2-5/16" BALL HITCH TO TRANSPORT UNIT.
5.
Use good judgment when transporting on a highway. Always maintain complete control. Regulate speed to road conditions.
WARNING: BE SURE ALL LIGHTS ARE WORKING PROPERLY BEFORE HIGHWAY TRAVEL.
6.
Travel speeds should be such that complete control and machine stability is maintained at all times.
7.
Where possible, avoid operating near ditches, embankments and holes. Reduce speed when turning, crossing slopes and rough, slick
or muddy surfaces.
8.
Make sure that the header is fastened securely to the transport before moving.
9.
Make sure that everyone is clear of equipment before applying power or moving the machine. NEVER position yourself under or near
header when mounting on header transport.
10. Never adjust, service, clean or lubricate the header transport until all power is shut off.
11. Ensure the implement is fastened securely to the towing unit.
12. Before unhooking the implement from the towing unit, properly block the wheels to prevent the implement from moving.
13. Never overload the header transport. Overloading the header transport is dangerous and can cause extensive damage.
14. Use caution when transporting. Be alert of the transport unit's overall width when approaching obstacles, such as post signs and
poles, along the road. Check the transport width of the unit to ensure clearance before entering bridges.
15. COMPLY WITH ALL SAFETY WARNINGS AND CAUTIONS IN THIS MANUAL AND IN THE COMBINE OPERATOR'S MANUAL.
6
Safety Rules
Advertisement
Table of Contents
