Table of Contents
Advertisement
Note: The right and the left side of the Header Transport is determined by facing the rear of the implement.
Mounting the Rear Axles
•
Secure the Dura-Flex Axles to the axle mounts located on the underside of the
header transport main frame using (4) 5/8" x 1-3/4" bolts with (8) 5/8" flat was-
hers and (4) 5/8" lock nuts.
NOTE: Position the axle so the spindle is located toward the rear of the axle
centerline.
Mounting the Tires
•
Secure one tire and wheel assembly to each of the rear hub assemblies using the
wheel nuts provided. Use a star pattern to tighten the spindle nuts according to
SAE standards.
Mounting the Rear Fenders
•
Place one base fender support rail on top of the two rear axles between the main
frame and spindle as shown.
Note: Ensure the vertical face of the support rail faces the outside of the trans-
port (toward the tires) and the support rail extends farther behind the second
rear axle than it does the first rear axle. If the support rail does not project
farther behind the second rear axle, the rail is located on the wrong side of the
transport and the other rail should be used.
•
Align the holes in the support rail with the rear axles and loosely secure to each
axle using a 3/8" x 3-1/2" x 3-1/2" UBolt, (2) 3/8" flat washers and (2) 3/8" lock nuts.
•
Repeat on opposite side of header transport.
•
Place the fender support arm on the header transport main frame and loosely secure to the angle iron support using (2) 1/2" x 1-1/2"
bolts, (2) 1/2" washers and (2) 1/2" lock nuts.
•
Mount the fender to the top of the fender support arm using (2) 3/8" x 1" SF bolts, (2) 3/8" rubber/metal washers and (2) 3/8" SF nuts.
Be sure the tear drop side of the fender is facing the outside of the transport.
•
Mount a Fender L-Bracket to the front and rear end of the fender using (2) 3/8" x 1" SF bolts, (2) 3/8" rubber/metal washers and (2)
3/8" SF nuts. Secure the other side of the L-Bracket to the Base Fender Support Rail using (2) 3/8" x 1" SF bolts and (2) 3/8" SF nuts.
•
Adjust the fender until the fender is centered above the tires to ensure proper clearance.
•
Tighten the Fender L-Bracket and both U-Bolts making sure to keep the fender in position.
•
Repeat for the opposite side of the header transport.
Set-Up Instructions
Fender Support Arm
Base Fender Support Arm
L-Bracket
1
7
5
4
3
6
8
2
11
Advertisement
Table of Contents
