Fujitsu D2619-N Technical Manual page 24

Main memory
Restrictions
The following configurations are not supported:
– 2DPC QRRDIMMs at DDR3-1066 speed or above
– 1DPC QRRDIMM at DDR3-1333 speed or above
– 3DPC SR/DR RDIMMs at DDR3-1066 speed or above
– Mixing QR RDIMMs on one channel and 3DPC SR/DR RDIMMs on another
channel on same CPU socket
– Mixing RDIMMs and UDIMMs anywhere on same system
– Any DIMMs using 256 Mbit, 512 Mbit or 4Gbit DRAM technologies
– x16DRAM on RDIMM or x4DRAM on UDIMM and QR UDIMM
– If 1.35 V (DDR3L) and 1.50 V (DDR3) DIMMs are mixed, the DIMMs will run
at 1.50 V.
– DIMMs with different timing parameters can be installed on different slots
within the same channel, but only timings that support the slowest DIMM will
be applied to all. As a consequence, faster DIMMs will be operated at
timings supported by the slowest DIMM populated. The same interface
frequency (DDR3-800, DDR3-1066, or DDR3-1333) will be applied to all
DIMMs on all channels on the platform (both processors).
– If one quad rank DIMM is used, it must be populated in DIMM slot 0 (farthest
away from the CPU) of a given channel.
I
For system relevant information please refer to the configurator of the
server:
http://ts.fujitsu.com/products/standard_server/tower/primergy_tx300s6.html
http://ts.fujitsu.com/products/standard_server/rack/primergy_rx300s6.html
(for the EMEA market)
http://primeserver.fujitsu.com/primergy/system.html
market)
24 Technical Manual
Features
(for the Japanese
D2619-N (RX/TX300 S6)
or