Caution; Note; Unpacking The Appliance; Overview Of The Components / Scope Of Delivery - Profi Care PC-BS 3085 A Instruction Manual

When the charging process of the battery is completed,
you should disconnect the charger immediately. A charge
up to 90 % is considered best.
Conversely, it is also preserving the battery more when
it is not discharged to 0 %. If the possibility arises, you
should already recharge the battery when it is reaching a
charge state of 30 %.
• Storage: Always store batteries in a dry place and at
moderate temperatures between 10 °C and 20 °C.
Also consider the effect of self-discharge! When the
accumulator is already empty, this effect may lead to
a deep discharge resulting in damaging the battery. If
you intend to store the battery for an extended period of
time, you can counteract this effect. We then recommend
charging the battery to approx. 40 % before storage. You
should check the state of charge after not more than a
month.

Unpacking the Appliance

1. Remove the appliance from its packaging.
2. Check the delivery scope for completeness.
3. Check the appliance for any transport damage, in order
to prevent hazards.

NOTE:

In case of any transport damage, contact your dealer
immediately. Do not use a damaged appliance!
Overview of the Components /
Scope of Delivery
1 Indicator lights
2 ECO button
3 Power supply connection socket
4 Carrying handle
5 On / off button
6 Dust container
7 Opening flap
8 Suction pipe release
9 Combined upholstery / brush nozzle
10 Upholstery / brush nozzle release
11 Joint nozzle release
12 Crevice nozzle
13 Floor nozzle release

14 Floor nozzle with turbo brush

15 Suction pipe

16 Accessory holder
17 Opener / locking of the flap
18 Dust container release
19 Motor housing / hand set
Not Shown
1 × Suction hose
1 × Power adapter
1 × Wall holder
PC-BS3085A_IM
2 × Wall plug
2 × Screw

Notes for Use

• The appliance is especially suitable for quickly vacuum-
ing small amounts of dry dirt or dust.
• The appliance is operated via charged battery. Charging
is done via the supplied power adapter.
• Direct power supply via power adapter is not possible.
• Hang the appliance onto the supplied wall mount when
not in use. It also serves as a charging station.

CAUTION:

The appliance can not stand upright on its own. If you
are not using the wall mount, gently place the vacuum
cleaner on the floor.
• This rechargeable battery vacuum cleaner is no
adequate replacement for a conventional floor vacuum
cleaner. Especially on shag-pile carpet, the cleaning
performance is not sufficient owing to its design.
• Contaminated filters reduce the suction power of the vac-
uum cleaner. Therefore, we recommend regular cleaning
of the existing dirt filters.
• Ideally, clean the filters whenever they have been subject
to a prolonged use.
• Please regularly check and clean the electric floor
nozzle.
• If necessary, clean heavily soiled floors multiple times
and / or use a conventional 230 V~ floor vacuum cleaner.

Switching the Appliance On / Off

• The button (5) turns the appliance on and off. Only press
the button briefly. You do not have to press and hold the
button.
• The appliance starts at high power level.
• Press the ECO button to toggle between low and high
power levels. In ECO mode, you can extend the life cycle
of the rechargeable battery.

Start-Up

Suction Pipe
• Insert the suction pipe with the two contact pins into
the connection on the hand appliance. It must audibly
engage.
• To disconnect the suction pipe, press the release (8) and
pull out the pipe at the same time.
• Use the bracket to attach the upholstery / brush nozzle
and the crevice nozzle to the suction tube. This way, you
always have the accessories at hand.
Floor Nozzle with Turbo Brush
• The floor nozzle is suitable for all floor coverings except
for shag-pile carpets.
47
08.07.20