formlabs Fuse 1 Manual page 29

2. Insert an unused powder identification card
into the card holder. The Powder Credit
screen appears on the touchscreen. The
Powder Credit screen displays the amount
of available powder credit on the new card
and the amount of powder credit currently
registered to the printer appears.
3. Tap Transfer to register the credit from
the identification card onto the printer.
The dialog box updates to show the new
powder credit totals.
4. After loading the powder credit onto the
printer, tap Done on the touchscreen.
Remove the card from the card holder.
5. Close the IR sensor door.
4.8.2 Checking available powder credit
When not loading or unloading powder credit
onto the printer, you can check how much
credit is available. This information can be
found on the Printer Status screen.
To check available powder credit:
1. Tap the printer icon in the left sidebar
on the touchscreen. The Printer Status
screen appears.
2. All available powder credit for the printer
is listed under the Powder Credit heading
in the Hopper section.
3. Tap the > icon next to Powder Credit.
The Powder Credit screen appears. The
Powder Credit screen shows additional
information about powder credits and
instructions for loading powder credits.
4. Tap Done
Credit screen.
to close the Powder
Preparation and setup | 27