Cisco Headset 500 Series Manual page 13

Accessories
Step 2
Plug the larger cable into the AUX port located next to the headset port.
Connect the Multibase to a Bluetooth Device
The Cisco Headset 560 Series Multibase can connect to Bluetooth devices such as a mobile phone or tablet.
The headset base appears on your call device as Cisco Headset followed by the last three digits on your
headset serial number.
Note You can find your headset serial number in the lower right corner on the underside of your base.
The multibase can store up to four different paired Bluetooth devices. If you already have four paired devices,
the base will replace the device which has not been used in the longest time.
Procedure
Step 1
Press the Bluetooth button on the back of the base twice to start pairing.
Step 2 Select your headset from the Settings menu on your device.
The Bluetooth LED lights white when pairing is successful.
Disconnect the Multibase from a Bluetooth Device
You can disconnect your Multibase from its paired Bluetooth call device.
Procedure
Step 1
Press the Bluetooth button on the back of the base once. The LED may take a moment to turn off.
Step 2 Press the Bluetooth button again to reconnect to the same call device.
Erase All Bluetooth Pairings
You can erase all saved Bluetooth device pairings.
Procedure
Press and hold the Bluetooth button on the back of the multibase for four seconds to clear the memory.
Connect the Multibase to a Bluetooth Device
Accessories
13