Installation Instructions; Electrical Connections - Bertazzoni PE244CER Use And Maintenance Instructions

EN
VITROCERAMIC HOB
User instructions
GENERAL
Carefully read the contents of this
instruction manual since it provides
important instruction manual regarding
safety of installation,
maintenance. Keep
manual for possible future consultation.
All the operations relating to installation
(electrical connections)
carried out by specialised personnel in
accordance with current regulations and
code.
SAFETY WARNINGS
It is recommended to use flat-bottom pans
with a diameter equal to or slightly larger
than that of the heated area (Fig.6). Do
not use pans with a rough base in order
to prevent scratching the heat surface of
the cooking hob. This appliance is not
suitable for use by children or persons
requiring supervision.
IMPORTANT
- Avoid spilling liquid, therefore to boil or
heat liquids, reduce the power of the
cooking zone.
- Please ensure when the appliance is
turned on, that there are no empty pots
left on top.
- After cooking, make sure to switch off
the heating
!!
If the surface of the hob is cracked, turn
off the appliance and disconnect from
the electrical main in order to avoid any
possible electric shocks.

INSTALLATION INSTRUCTIONS

These instructions are for a specialized
installer and are a guide for the installation
process, regulations and maintenance
in accordance with the law and current
standards. If the built-in oven or any other
appliances that produce heat, need to be
installed directly underneath the cooking
hobs in ceramic glass, IT IS NECESSARY
THAT THE APPLIANCE (oven) AND
THE COOKING HOBS IN CERAMIC
GLASS ARE ADEQUATELY ISOLATED
(fig.3). Failure to follow this precaution,
could cause a malfunction in the TOUCH
6
use
the Instruction
must
element
WARNING !!
CONTROL system.
POSITIONING
The domestic appliance was built in order
to be built into a work surface, the way
it is illustrated in Fig 1. Place sealing
gasket along the whole perimeter Fig. 4
(the dimensions of the cut Fig.1). This
and
sealing gasket is included in the product
packaging, if this is lost you can request it
again. This operation is necessary to avoid
any liquids penetrating the
be
the domestic appliance into place with 4
supporters, keeping in mind the width of
the surface (Fig.2). If the lower part of the
appliance after installation, is accesible
via the lower part of the furniture, it is
necessary to mount a separating panel
keeping in mind the distances indicated
(Fig.3). It is possible to mount the hob in
Flush mode. Following the measurements
in fig. 10, i.e. with a distance from the hob
to the hob of 3 mm [0,11"].

ELECTRICAL CONNECTIONS

(Fig.5)
Electrical safety instructions
• All electrical work should be carried out
by a suitably qualified and competent
person, in strict accordance with current
local and national safety regulations.
Installation, repairs and other work by
unqualified persons could be dangerous.
The manufacturer cannot be held liable
used.
for unauthorised interventions.
• A damaged cable must be replaced by a
suitably qualified electrician with a special
connection cable of the same type of the
one originally provided with the cooktop.
• Ensure power is not supplied to the
appliance until after installation or repair
work has been carried out. The appliance
must only be operated when built-in. This
is to ensure that all electrical parts are
shielded. Live parts must not be exposed.
•Do not connect the appliance to the
mains electricity supply by an extension
cord. These do not guarantee the required
safety of the appliance.
• Connection should be made via a suitable
isolator which complies with national and
local safety regulations, and the On/Off
switch should be easily accessible after
the appliance has been built in.
worktop.Lock