Download Print this page

Bluetooth Wireless Technology - Whale InstantMatch SDS236T Quick Connect Manual

Instant match transformer

Advertisement

BLUETOOTH MINI A5 (2018):Layout 1 27/03/2018 14:57 Page 3
Plumbing of the Waste Pipe
Bluetooth
A wireless Bluetooth connection may be used to allow the SDS236T
(755.678) Whale Instant Match
Mira Advance Flex Extra (J09N) shower without the use of a physical
hardwired connection or external flow sensor to activate the pump.
To set up the wireless connection, please follow the process below.
Important Information
Please read the following information before setting up a luetooth
between the Whale Instant Match
• The electrical wiring must conform to EU wiring regulations BS7671:2008 Part 7 (17th Edition).
®
• The Bluetooth
Advance Flex Extra (J09N) shower.
• Previous Whale Instant Match
wireless technology enabled Mira Advance Flex Extra Shower (J09N).
®
• Bluetooth
wireless technology enabled transformers can be easily identified by the blue test button.
• For optimum signal strength, mount the transformer within 5 metres of the shower.
• Locating the transformer outside of a 5 metre radius may cause a communication breakdown between
the transformer and shower, resulting in intermittent or complete failure to operate.
• Be aware that in very rare situations, dense building material, metallic objects such as steel baths and
foil lined plaster board, or electronic devices may interfere with the Bluetooth
and result in intermittent failure. In this situation you should relocate the transformer closer to the shower.
• A hardwired connection must be established if a Bluetooth
made between the shower and transformer.
• If any component or cord is damaged, it must be replaced by a qualified person to avoid a hazard.
Set Up
1. Shower settings
• Before beginning the Bluetooth
registration process, please ensure that the "Pump LK2"
switch inside the Mira
been set to the "ON" position, and that the "Pump LK1"
and "Pump LK3" switches remain in
the "OFF" position as per the diagram shown.
• At this stage please ensure that your transformer is
set to be used with Bluetooth
the flow sensor setting must be set to 7 for "Bluetooth"
and the pipe inlet diameter must be set to 1 for 15mm.
®
wireless technology
®
transformer to communicate with the
®
transformer and Mira
function of the Whale Instant Match
®
Wireless transformers cannot be connected wirelessly to the Bluetooth
®
wireless technology
®
Advance Flex Extra (J09N) has
®
wireless technology:
WARNING
®
wireless technology connection
®
Advance Flex Extra (J09N) shower:
®
transformer will only work with the Mira
®
wireless technology signal
®
wireless technology connection cannot be
Blue Jumper - Sensor Position 7
Grey Jumper - Over run 10 Seconds
Red Jumper - Pipe inlet 15mm
®
®
OFF
ON
BEAB
43 DEG C
45 DEG C
RESERVED
6L/MIN
PUMP LK3
PUMP LK2
PUMP LK1
Whale
Transformer
Settings

Advertisement

loading