Advertisement
BLUETOOTH MINI A5 (2018):Layout 1 27/03/2018 14:57 Page 12
Whale Instant Match
Flow Switch Connections Cont'd
Mixer Shower Settings
Step 1: Turn Dip switch 2 to the 'ON' position.
Step 2: Move red jumper to pipe size '2' for 22mm inlet pipe.
Step 3: Move the blue jumper to increase or decrease the pump
speed as required, using the below table as a guide.
Step 4: Move the grey jumper to increase or decrease the pump
overrun if necessary. 30 is the recommended setting for
use on mixer showers.
Note: An additional flow switch is available in the
AK1570 Mixer Valve Conversion kit (sold separately).
Jumper
Position
1.
2.
3.
4.
5.
6.
7.
• Flow rates are nominal values only.
This will vary depending on pipework.
©Copyright Whale 2018 - All rights reserved. Reproduction in whole or in part without permission is prohibited. WHALE® and WHALE
INSTANT MATCH® are registered trademarks of Munster Simms Engineering Limited, Bangor, Northern Ireland trading as Whale.
Whale's policy is one of continuous improvement and we reserve the right to change specifications without prior notice. Illustrations are
for guidance purposes only. Neither the accuracy nor completeness of the information contained in this or any product literature is
guaanteed by the Company and may be subject to change at its sole discretion.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Munster
Simms Engineering Ltd (trading as Whale) is under licence. Other trademarks and trade names are those of their respective owners.
MIRA® is a registered trade mark of Kohler Mira Limited.
TRITON® is a registered trade mark of Triton Showers a division of Norcros Group (Holdings).
REDRING® is a registered trade mark of Redring Xpelair Group Limited.
SIKA® is a registered trade mark of Dr. Siebert & Kuhn GMbH & Co. KG
GEMS® is a registered trademark of Gems Sensors & Controls.
GRUNDFOS® is a registered trademark owned by Grundfos Management A/S or Grundfos A/S, Denmark.
®
Transformer
Flow Rate
(LPM)
7.5 - As shown opposite
8.0
8.5
9.0
9.5
10.0
11.0
Please ensure that water flow
through the sensor is in the direction
of the arrow on the sensor.
Whale
Dip Switches
Blue Jumper - Sensor Position 1
Grey Jumper - Over run 10 seconds
Red jumper - Pipe inlet 15mm
Blue Jumper - Sensor Position 1
Grey Jumper - Over run 30 Seconds
Red Jumper - Pipe inlet 22mm
Flow Switch x 2
®
Transformer Settings
Advertisement
