Download Print this page

Whale Instant Match SDS236T Quick Connect Manual

Hide thumbs Also See for Instant Match SDS236T:

Advertisement

Quick Links

SDS236T
Instant Match Transformer
Quick Connect Guide
WITH

Advertisement

loading
Need help?

Need help?

Do you have a question about the Instant Match SDS236T and is the answer not in the manual?

Questions and answers

Summary of Contents for Whale Instant Match SDS236T

  • Page 1 SDS236T Instant Match Transformer Quick Connect Guide WITH...
  • Page 3: Bluetooth Wireless Technology

    • The electrical wiring must conform to EU wiring regulations BS7671:2008 Part 7 (17th Edition). ® ® ® • The Bluetooth function of the Whale Instant Match transformer will only work with the Mira Advance Flex Extra (J09N) shower. ® ®...
  • Page 4 RESERVED RESERVED 1 6L/MIN PUMP LK3 RESERVED 2 PUMP LK2 BLE PUMP ENABLE PUMP LK1 WIRED PUMP MODE Whale Transformer Settings Blue Jumper - Sensor Position 7 Grey Jumper - Over run 10 Seconds Red Jumper - Pipe inlet 15mm...
  • Page 5 Easy Pairing for Mira Advance Flex Extra J09N Plumbing of the Waste Pipe Manufactured after Week 2 2019 ie 02/19 on production date label located on base of shower. 2. Transformer set up • Switch the mains electric supply to the transformer ON and wait to hear the audible beep from the transformer.
  • Page 6 Pairing setup for Mira Advance Flex Extra lumbing of the Waste Pipe J09N Manufactured prior to Week 2 2019 2. Transformer set up • Switch the mains electric supply to the transformer ON and wait to hear the audible beep from the transformer. The light on the transformer will now flash red to indicate ®...
  • Page 7 5. Slowly turn the dial on the shower to position 2 6. Pairing the shower to the Whale Instant Match transformer ® • Press and release the start/stop button on the shower. The status light on the shower will now flash blue to indicate that the shower is in pairing mode.
  • Page 8 PCB board may require the Bluetooth wireless technology ® connection between the shower and Whale Instant Match transformer to be terminated and paired again. To unpair the transformer from the shower, please follow these steps.
  • Page 9 • Remove front cover from Mira shower RESERVED 1 • Move DIP switch ‘BLE PUMP ENABLE’ to ‘ON’ position (see opposite) RESERVED 2 • Replace front cover BLE PUMP ENABLE WIRED PUMP MODE • The shower is ready to be paired with Whale transformer...
  • Page 10: Terminal Block

    Compatible showers and their pump connections may be found below. Mira Advance Flex Extra 1.1785.005 (J09N) ® ® Wired Connections to the Whale Instant Match Transformer Ensure all LK settings are set to ‘OFF’ for hardwired connection BEAB CARE MODE...
  • Page 11 Grey Jumper - Over run 10 Seconds Red Jumper - Pipe inlet 15mm Redring ® Shower Connections and Settings Redring Selectronic WP ® (SEL85WP or SEL95WP) Wired Connections to the Whale ® Instant Match Transformer Redring Shower Connections and Settings ® Whale...
  • Page 12: Sensor Connection

    (Venturi) Connection ® ® When connecting to the Grundfos Venturi sensor it is important to connect an earth wire ® from the Venturi sensor to the signal earth connection on Whale transformer (shown below). ® Whale Transformer Settings ® Venturi...
  • Page 13 In a situation where a Bluetooth wireless technology or hardwired connection with the shower cannot be established, or a suitable flow sensor has not been fitted, the Whale SDS236T Instant Match transformer can be used with an AK1568 flow switch to activate the pump.
  • Page 14 Whale Instant Match Transformer ® Flow Switch Connections Cont'd Mixer Shower Settings Step 1: Turn Dip switch 2 to the 'ON' position. Step 2: Move red jumper to pipe size '2' for 22mm inlet pipe. Step 3: Move the blue jumper to increase or decrease the pump speed as required, using the below table as a guide.
  • Page 15 ©Copyright Whale 2019 - All rights reserved. Reproduction in whole or in part without permission is prohibited. WHALE® and WHALE INSTANT MATCH® are registered trademarks of Munster Simms Engineering Limited, Bangor, Northern Ireland trading as Whale. Whale’s policy is one of continuous improvement and we reserve the right to change specifications without prior notice. Illustrations are for guidance purposes only.
  • Page 16 0345 9090 912 drainagesupport@whalepumps.com www.whalepumps.com Whale, 2 Enterprise Road, @Whalecare Bangor, Co. Down, BT19 7TA, N.Ireland Ref. 182.606_v4_1019...