Starting With The Timer - Silvercrest SKMD 1000 A1 Operating Instructions Manual

4. Place a paper filter (size 1x4) with fold-
ed sides in the filter holder 11. When it
is folded, the paper filter fits better in
the filter holder 11 and the seams are
prevented from tearing.
5. Place coffee grounds into the filter. For
medium-strength coffee, put one coffee
spoon (around 7 – 8 g) of coffee pow-
der per cup into the filter. Use ground
coffee powder for filter coffee. If you
grind the coffee yourself, grind it on a
medium fineness level.
6. Close the lid 1 of the coffee machine 6.
7. It is very important to screw the
lid 9 on the thermal jug 8.
The lid 9 is closed by turning it clock-
wise.
8. Place the thermal jug 8 in the
coffee machine 6.
9. Press 18. The red LED 19 lights up
and the brewing process will start after
a short time.
10.The red LED 19 goes off approx.
5 – 6 minutes after the end of the brew-
ing process.
11.Figure B: take the thermal jug 8 by the
handle out of the coffee machine 6,
open the lid 9 slightly (by turning anti-
clockwise) and pour out the coffee.
12.Figure C: close the lid 9 again (by
turning clockwise) to keep the coffee
hot.
NOTE: the brewing process can be stopped
by pressing the button
ton 18 repeatedly until all LEDs have
gone off.
18. Press the but-

7.4 Starting with the timer

Enter the desired time if the timer shall start
the coffee machine at a certain time.
NOTE: the timer cannot be set if a brewing
process has already started (i.e. if the red
LED 19 is lit).
The timer can be set up to 24 hours in ad-
vance.
1. Connect the coffee machine 6 with the
mains plug 7 to a wall socket.
2. Fill the coffee machine as usual with cof-
fee powder and water.
3. Close the lid 1 of the coffee machine 6.
4. It is very important to screw the
lid 9 on the thermal jug 8.
The lid 9 is closed by turning it clock-
wise.
5. Place the thermal jug 8 in the coffee
machine 6.
6. Press the button
TIMER appears at the top in the dis-
play 13.
7. Press HOUR 17 in order to set the
hours. Keep the button pressed to run
through the options quickly.
8. Press MIN 16 in order to set the min-
utes. Keep the button pressed to run
through the options quickly.
9. Press 18 twice. The white LED 14
lights up. This indicates that the timer is
active.
10.At the time that has been set, the brew-
ing process will start automatically and
the red LED 19 will light up.
11.The red LED 19 goes off approx.
5 – 6 minutes after the end of the brew-
ing process.
NOTE: you can stop the timer by pressing
the 18 button. Press
the white LED 14 is lit. All LEDs are off.
15 repeatedly until
18 once while
23
GB