Care And Maintenance - horsch Tiger 3 MT Operating Instructions Manual

In case of changes which concern the data in
the type approval, this type approval needs to
be renewed.

Care and maintenance

Inappropriate care and maintenance put the
operational safety of the machine at risk. This
can lead to accidents with severe or even fatal
physical injuries.
Conform to prescribed schedules for repetitive
¾
tests or inspections.
Service the machine according to the mainte-
¾
nance plan, see chapter Care and maintenance.
Only perform the work described in these
¾
operating instructions.
Before starting maintenance and service work
¾
park the machine on level and firm ground and
secure it against rolling away.
Depressurise the hydraulic system and lower
¾
or support the implement.
Prior to working on the electrical system,
¾
disconnect it from the electric current supply.
When performing welding work on the ma-
¾
chine, disconnect the cables from computers
and other electronic components. The ground
connection must be as close as possible to
the welding point.
Before cleaning the machine with high pres-
¾
sure cleaner cover all openings, which should
stay clear of water, steam or cleaning agents
for reasons of safety or operation. Do not aim
the water jet directly on electric or electronic
components or bearings. When cleaning with
high pressure cleaning equipment or steam jet
keep a distance of at least 50 cm to machine
components.
After cleaning, check all hydraulic lines for
¾
leaks and loose connections.
Check for chafing and signs of damage. Rem-
¾
edy any faults immediately!
Screw connections loosened for the purpose
¾
of care and maintenance work must be
retighten after work is completed.
Do not clean new machines with a steam jet
¾
of a high pressure cleaner. The paint takes
approx. 3 months to cure and could thus be
damaged if this time has not yet expired.
All other maintenance and repair tasks,
¾
which are not described in the operating
instructions, must only be carried out by
an authorized professional workshop or
by an operator who has been trained by
HORSCH for this purpose.
13