Table of Contents
Advertisement
If you purchased the USB LCM, please use the enclosed USB extension cable (A-male to A-
female) to
connect to the
▪
Connect the USB LCM to the female side of the USB extension cable.
▪
Connect the male side of the USB extension cable to the USB port on the system front pillar.
To learn more how to use USB LCM, please refer to the chapter 4.4, Accessing the Management
USB LCM in the
XCubeFAS XEVO Software
Configuration for the System
After powering on the system, the next step is to discover the system on the network and start
the initial configuration. To discover the system, we suggest downloading our XFinder
application from the QSAN web site; this will hunt the network for your new AFA and allow you
to access it via the XEVO GUI. For more information about discovering your system and the
initial configuration, please refer to the chapter 3, Getting Started in the
Software
Manual.
4.
Q
UICK
This chapter provides quick maintenance and instruction of removing / installing FRU (Field
Replaceable Unit) or optional components of all the XCubeFAS series models. All the XCubeFAS
models feature the HA design, any of the FRU components can be hot swapped and replaced
with zero downtime in the rare event of a component failure. If you encounter any issues
caused by FRU components while operating the XCubeFAS, please refer to related section and
follow the quick troubleshooting procedures step by step.
Quick Maintenance
38
© 2021 QSAN Technology, Inc. All rights reserved.
www.qsan.com
Connecting the Optional USB LCM
system. The Following procedures are for the USB LCM connection:
Manual.
Discover and Carry Out the Initial
M
AINTENANCE
XCubeFAS Series
Hardware Manual
XCubeFAS XEVO
Official
Document
Advertisement
Table of Contents
