Using The Device - VeriFone UX301 Installation Manual

Using the Device

Using the Multi-Card
Reader
To conduct a card
transaction
WARNING
NOTE
CAUTION
Card transaction procedures vary depending on the application. Verify the proper
procedure with your application provider before performing a card transaction.
The UX301 supports magnetic stripe cards as well as smart cards. Use the
following steps in conducting UX301 card transactions.
Position the card with the magnetic stripe facing downward and to the right of the
card, or with the chip on top of the card and towards the card slot (see
Figure 14 Using the Multi-Card Reader
1
If using a magnetic stripe card, insert the card fully into the slot, then remove
the card in a smooth continuous motion.
You will lose transaction data files not yet stored in memory if there is a disruption
in power supply during a transaction.
The LEDs or peripheral display will indicate if the transaction is complete.
With magnetic stripe cards, card removal usually completes the transaction.
2
If using a smart card, insert the card and follow the on-screen instructions
before removing the card.
When using a smart card, leave the card in the reader until the transaction is
complete.
Premature card removal can void the transaction.
S
Using the Device
Figure 14).
UX301 I G
NSTALLATION UIDE
ETUP
23