Mounting The Device - VeriFone UX301 Installation Manual

Mounting the
Use the following procedure to mount the UX301 to a suitable mounting surface.
Device
For proper operation of the Anti-Removal Switch (ARS), do not use additional
CAUTION
gaskets or washers. Use the unit and its accessories as they are upon removing
from the packaging.
CAUTION
Make sure that your mounting frame has a thickness of 2 mm.
NOTE
Your mounting surface may have different installation instructions. Refer to the
user guide of your mounting device for further information.
1
To mount the unit
Figure 11
2
3
You can also mount the UX301 using welded screw bolts on the inner side of the
NOTE
mounting plate. This prevents any vandalism of the screw heads on the outer
surface.
Align the UX301 stud holes with the holes on the mounting surface.
Mounting the UX301
Place the reader flush onto the mounting slot.
Secure the unit with M5 nuts with a minimum length of 12 mm. Tighten the
nuts using to the recommended torque of 7.0 kgfcm (6.1 lbf.in).
S

Mounting the Device

UX301 I G
NSTALLATION UIDE
ETUP
19