Grounding The Units - VeriFone UX301 Installation Manual

S
ETUP

Grounding the Units

NOTE
Grounding the
Units
NOTE
To ground the units
20
UX301 I
NSTALLATION
4
Connect flexible tubing with 9mm inner diameter to the drain nozzle at the
bottom of the UX301 (see
appropriate drainage area.
The nozzle drains water out of the bezel area through the flexible tube. Ensure
that the tubing is properly dressed and mounted as vertical as possible (without
any loops) to ensure smooth water drainage.
If you connect the UX301 to a UX-series PIN pad, use the following steps to
ground your units.
For cable use and ordering information, see
1
Remove mounting nuts from the back of the UX301 and the PIN pad unit (do
remove the nut securing the PIN pad cable retainer).
Figure 12 Grounding the UX301 and PIN Pad Units
2
Attach one end of the grounding cable (VPN WIR159-302-02-A) to the UX301
and connect the other end to a ground installation. See (C) in
3
Use another grounding cable (VPN WIR159-302-02-A) and attach one end to
the PIN pad mounting bolt. Connect the other end to a ground installation. See
(C) in Figure 12.
4
Connect the UX301 to the PIN pad with another grounding cable
(VPN WIR159-302-01-A) using the same mounting bolts. See (A, B) in
12.
5
Replace the nuts and tighten to the recommended torque of 7.0 kgfcm (6.1
lbf.in).
G
UIDE
Figure 2) and place the other end of the tubing at an
Accessories and
UX100
B
C
Documentation.
A
C
Figure 12.
Figure