Connecting Power Supply - VeriFone UX301 Installation Manual

Connecting
Power Supply
CAUTION
NOTE
Power Connections
Not all UX301 configurations and device contexts require the use of a power
supply. Verifone ships power supplies with the UX301 as required.
If you have questions about which power supply to use, contact your Verifone
representative. For more information, see
Using an incorrectly rated power supply can damage the unit or cause it to
malfunction. The power rating for UX301 is 9 V DC to 43 V DC.
Verifone recommends the following PSUs:
•
12 V, 3.3 A L5 EEF PSU for UX301 (VPN PWR159-001-01-A)
•
12 V, 3.3 A L6 EEF PSU for UX301 (VPN PWR159-002-01-A)
•
24 V Rhino PSU for UX301 Petrol (VPN CPS12490-4A-R).
See Specifications for detailed power supply information.
Attach and route all cables between the UX301 and all peripheral units before
connecting to the power source.
To protect against possible damage caused by lightning strikes and electrical
surges, Verifone recommends installing a power surge protector.
The UX301 connects to external power using 6-pin ferrite cable (VPN
) from the power port on the model-dependent board (see B in
01-B
For more information regarding your card reader configuration, contact your local
Verifone service provider. For cable ordering information, see
Documentation).

Connecting Power Supply

Accessories and Documentation.
Accessories and
UX301 I
NSTALLATION
S
ETUP
CBL159-309-
Figure 2).
21
G
UIDE