Liquiflo H Series Installation, Operation & Maintenance Manual page 25

Liquiflo Installation, Operation & Maintenance Manual
b. Push the retaining ring into the outer groove.
c. Tap the retaining ring down and out of the outer groove by using either:
[A] a rubber mallet and specially made tool (see Appendix 2), or
[B] a rubber mallet and open-end wrench that is slightly larger than the shaft diameter.
A
______________________________________________________________________________
d. Push the retaining ring down the shaft and into the inner groove.
CAUTION!
Be careful not
to scrape or
gouge the
drive shaft.
NOTE: Polish out any
rough marks on shaft
using very fine sand-
paper or polishing cloth.
_____________________________________________________________________________________
15 Insert key (13) into the drive shaft (20).
NOTE: The straight edge of the key should
be parallel to the drive shaft when installing
the inner magnet on the shaft.
_____________________________________________________________________________________
Step 14c:
Either Method
can be used
Retaining Ring Tool
Open-end Wrench
25
MAG-DRIVE Gear Pumps
Models H1-H9, 31-39 & 311 - MC
B
Retaining Ring
in Inner Groove
Key
Outer
Groove