Electrical Connections; Connect Dc Wires; Connect The Temperature Sensor; Connect The Alarm Relay - Victron energy Lynx Shunt VE.Can Manual

Figure 4. Connection sequence when connecting two Lynx modules
M8 bolt
M8 Spring washer
M8 Washer
Lynx module
Correct placement of the M8 washer, spring washer and nut.

6.2. Electrical connections

6.2.1. Connect DC wires

This chapter might not apply if the Lynx module is connected to other Lynx modules, like can be the case for the Lynx Smart BMS
or the Lynx Shunt VE.Can.
For all DC connections the following applies:
• All cables and wires connected to the Lynx module need to have been fitted with M8 cable lugs.
• Pay attention to the correct placement of the cable lug, washer, spring washer and nut on each bolt when attaching the cable to
the bolt.
• Tighten the nuts with a torque moment of 14Nm.
Figure 5. Correct mounting sequence DC wires
Cable lug
M8 bolt
M8 Spring washer
M8 Washer
Lynx module
Correct placement of the M8 Cable lug, washer, spring washer and nut

6.2.2. Connect the temperature sensor

An optional battery temperature sensor can be connected to the green terminal with the + and - symbol.
The connector can be removed from the terminal, for easy connection.
The temperature sensor is polarity sensitive. Connect the black wire to the - terminal and the red wire to the + terminal.
Temperature sensor conenction Lynx Shunt VE.Can

6.2.3. Connect the alarm relay

The alarm relay connector is the black 2-way connector. See below image for its location.
Page 12
Lynx Shunt VE.Can
Lynx module
Temperature
sensor connector
Installation