Siemens RAJA+ ЗTE7111-2SC18-1A Series Installation, Maintenance & Troubleshooting Manual page 4

Installation, Maintenance & Troubleshooting guide | Version 01
1: Amber LED
2: Starter Mode selecting switch
3: LMRA
4: LMRA On delay dial
5: Contactor
6: Thermal overload relay
7: Relay setting dial
8: Green NO Aux.contact
9: Red NC Aux.contact
10: Relay Red test button
11: Relay reset button
12: Incoming terminal block (TB1)
13: Outgoing terminal block (TB2)
14: Earthing screw
15: Mounting hole
16: Links
17: Gasket
18: Grommet
19: Wiring diagram label
- For indicating the healthiness of incoming power supply
- For the selection of starter operating mode (Auto,Manual, Bypass)
- For checking the healthiness of incoming power supply
- On delay setting dial (0.5-5min)
- Dial which can be set according to the motor current
- For switching ON the motor if starter enclosure is open
- For switching OFF the motor if starter enclosure is open
- For checking the relay trip circuit
- For resetting the relay
- For connecting the incoming supply cables
- For connecting the outgoing supply cables to motor
- Starter earthing provision
- 4x holes for mounting the starter
- Links of ON & OFF push buttons
- For the incoming & outgoing cable passage
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
4