Maintenance; Operation - Makita DUB361 Instruction Manual

1
► 1 . Button
To remove the long nozzle, press its both buttons and
with the buttons being pressed pull it out.
Installing the shoulder strap
► 1 . Hanger
Pull the hanger out of the tool.
Hook the shoulder strap onto the hanger of the tool.
Before use, adjust the length of strap so that it is easy
to work with it.

OPERATION

Blowing
Hold the blower firmly with a hand and perform the
blowing operation by moving it around slowly.
When blowing around a building, a big stone or a vehi-
cle, direct the nozzle away from them.
When performing an operation in corner, start from the
corner and then move to wide area.

MAINTENANCE

CAUTION:
1
• Always be sure that the tool is switched off and
the battery cartridge is removed before attempt-
ing to perform inspection or maintenance.
• Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
Cleaning
1
From time to time, wipe off the outside of the tool using
a cloth dampened in soapy water.
Replacing carbon brushes
► 1 . Limit mark
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
6 ENGLISH
1