Appendixes; Wiring Diagrams; Appendix 2 Warranty - Hussmann Austral H1 Installation Manual

Installation manual
It has increased noise
The dissipater heater is on
despite the tray water level
being low
The compressor never stops

Appendixes

Appendix 1
Appendix 2
The information in this manual is for "Qualified Persons Only". It is NOT an Installation Guide for "NON Qualified
Persons".
To obtain warranty information or other support, contact your nearest Hussmann representative.
Please include the following:
Customer site location.
Cabinet model & serial number of product.
Reason for warranty.
_________________________________________________________________________________________________________________________
Page 13
The circuit breaker has tripped.
The unit is damaged
The condenser is dirty
The evaporator is blocked with ice
The compressor is damaged
Level controller faulty
Rust, salt or other deposits bridging the
sensor input signal
The sensor tip(s) short circuited
The condenser is dirty
The fluid is missing
The digital control unit is not regulated or is
The evaporator is blocked with ice
Table 1
Wiring diagrams – Supplied with each new case.
Warranty
damaged
Troubleshooting
H1 Self Contained Multideck
Contact service provider.
Contact service provider
Contact service provider
Contact service provider
Contact service provider
Hussmann