Winmate Porty G4 Quick Start Manual page 25

Chapter 3: First Time Operation 25
3.8 G-Sensor Wake up
a. Implement Daimler MCU Control and perform COM Port connect to COM1 then set G-Sensor enable.
b. Click Get G-Sensor Wake and make sure G-Sensor Status =Enable。
c. Click on the G-Sensor lnt to adjust the sensitivity of G-Sensor (10 to 0).
d. Allow the system to enter the Sleep / Hibernate / Shut down Mode and motion the
Windy Plus to wake up it. Click get Event to confirm whether wake up by G-Sensor.
e. Click Get G-Sensor Table and make sure whether the count and time information are
correct.